Master Forge Cart

Discussion in 'Propane Smokers' started by bigmal-va, May 26, 2011.

  1. As I am unable to find a cover for my new MF, I decided I'd build a cart to move it in and out of the garage.  Mind you, it is NOTHING fancy, but it is solid and gets the job done.

    [​IMG]

    I built it out of 2"x4" pressure treated lumber.  I set the bottom pieces flat, applied some gorilla glue and secured with clamps.  After the glue dried, I secured with L-brackets and screwed in.

    [​IMG]

    Then, I ripped 2" x 4"s down to 1" wide to make a rail.  I didn't want the smoker to slide off when wheeling it in and out of the garage.  Added some casters and secured the smoker to the cart with a couple of screws through the cart and legs.

    Like I said, it's nothing pretty, but gets the job done.
     

Share This Page