I like the site and the people....

Discussion in 'Roll Call' started by bondvader, Jul 23, 2007.

  1. bondvader

    bondvader Smoke Blower

    Been reading alot on the site and the forum. Decided to join, I just started with my GOSM last week. I've had it for 3 months but I didnt have time to play. It seems that posts on this forum seem to get replies not like the other sites. Anyway. I did have trouble keeping my temp below 285. I was thinking of adding a dampner around the base of the burner, like a wrap around that control's the inflow. Could that solve my probleum?
     
  2. mossymo

    mossymo Master of the Pit OTBS Member SMF Premier Member

    Welcome to the SMF !!!
    I do not have GOSM experience, but I am positive someone with the knowledge will be along shortly.
     
  3. brennan

    brennan Smoking Fanatic OTBS Member

    I would assume that you would just need to cut off gas flow til you get the right temp...no sense in spending money where you don't need to, save it for food.
     
  4. jts70

    jts70 Smoking Fanatic OTBS Member

    Couple of questions.

    1. Are you using the built in thermo? You should be using a digital or some other type (do not trust the built in)

    2. does the size of the flame change when you use the temp nob?

    3. how are you shutting down the unit? do turn the gas on your GOSM first or on the reg or on the tank? You should be shutting down on the GOSM first

    There is a as possiblity that you have a bad regulator.
    You may need to call MFG and have them ship a new one.
    Let me know, I'll try to help
     
  5. blackhawk19

    blackhawk19 Master of the Pit OTBS Member

    Welcome, I don't have a GOSM but i will be getting one next week to go with
    my ECB so I will be interested in the replies you get. Sign up for jeff's
    5-Day eCourse and check out Deejay Debs site
    http://www.deejayssmokepit.net/
     
  6. bondvader

    bondvader Smoke Blower

    Thanks. I had a smaller thermo that shot passed 240 while the unit reading was 300. The flame does change when I turn the knob but the lowest setting can get puts me around 285.
    I shut it down on the unit first then the tank.
     
  7. gypsyseagod

    gypsyseagod Master of the Pit OTBS Member

    welcome to smf.
     
  8. deejaydebi

    deejaydebi Smoking Guru

    Welcome Bondvader -

    I agree with Brennan try adjusting the gas first!
     
  9. ron50

    ron50 Master of the Pit OTBS Member SMF Premier Member

    NY
    Welcom to SMF, enjoy your stay.
     
  10. hawgheaven

    hawgheaven Master of the Pit OTBS Member

    Welcome aboard bondvader, glad to have you with us!

    Hook up with Jeff's free 5-day ecourse, it is chocked full of great info! Plus, don't forget to take pics of your smokes... we refer to them as "Q-view"...

    Have fun!
     
  11. hillbillysmoker

    hillbillysmoker Master of the Pit OTBS Member

    Welcome to the forum. Nice to see you here.
     
  12. vulcan75001

    vulcan75001 Smoking Fanatic OTBS Member

    Hello there and welcome to the forum..
    I have the Big Block, and have had no problems controling the temps down to the 150* range...sure sounds like you have a regulator problem...and from reading the posts from others, that have had similar problems..they contacted the company, and have had the regulator replaced...don't let them tell you that is the nature of the beast or to crack the door open to help control the temps ...that is pure BS...Good luck...
     
  13. ultramag

    ultramag SMF Events Planning Committee

    Welcome to SMF bondvader!!! vulcan75001 gives you great advise. The regulator was a problem on several GOSM units in the past. I would contact them and have them send me a replacement and as noted above accept no excuses or that's just how it is stories. Good luck and let us know how it comes out for ya.
     
  14. dutch

    dutch Smoking Guru Staff Member Administrator Group Lead OTBS Member SMF Premier Member

    Bondvader, I use the GOSM meself. I never run the regulator on the tank full open. I'll open the valve all the way and then turn it back down to about half. This is out of habit cuz if you run the valve full open in the winter time, the regulator will freeze.

    Also make sure that you have water in the water pan, running a dry pan will give you higher temps as well.
     
  15. bondvader

    bondvader Smoke Blower

    Thanks, I did take the 5 day course. I liked it alot, it helped. I will try to back the gas tank down first before I break out my tools!
     
  16. jts70

    jts70 Smoking Fanatic OTBS Member

    It sounds like you reg for sure.
     
  17. Bondvader, I also had the same problem the first time I used my GOSM making jerky. I was using the smoker without water in the pan to dry the jerky. I found that if I set the smoker on low and the closed the valve on the propane tank to about one turn open I could get the temps I wanted. I have since smoked butts, lots of ribs and chicken with the water pan full and have not had a problem with the temps getting out of control. In fact I usually run just under the medium setting to stay around 225 deg.
     
  18. bondvader

    bondvader Smoke Blower

    Thanks, I'll try it tonight
     
  19. bondvader

    bondvader Smoke Blower

    I tryed opening the tank a qtr turn with a larger bakers square pie plate for the chunks. I think I can hold around 240 on a cooler afternoon and no wind. I hink I will have to swap the regulator. Is that an item I can buy instead of going through the company?
     
  20. vulcan75001

    vulcan75001 Smoking Fanatic OTBS Member

    you already bought it once and it was defective....let the company send you a replacement...
     

Share This Page