Grommet

Discussion in 'Slicers, Grinders, Tools, Equipment' started by azrocker, Feb 23, 2009.

  1. azrocker

    azrocker Smoking Fanatic SMF Premier Member

    I would like to put a pass through grommet on my smoker for probes. Any suggestions on material? Does cork hold up to the heat?
     
  2. rsands

    rsands Smoke Blower

  3. azrocker

    azrocker Smoking Fanatic SMF Premier Member

    thanks 500 should be more then enough![​IMG]
     
  4. bbq bubba

    bbq bubba Master of the Pit OTBS Member

    Rubber grommets work great!

    [​IMG]
    By imn88fan
     
  5. richoso1

    richoso1 Smoking Guru OTBS Member SMF Premier Member

    Good and simple advise from Bubba. I've used them for over 5 years on a Brinkman and no problems yet.
     
  6. rickw

    rickw Master of the Pit OTBS Member

    That's a great idea, I'll use them on my next drum project.
     
  7. travcoman45

    travcoman45 Master of the Pit OTBS Member

    Here's what I use, get in the electrical dept a yer done it ta yerself store, couple bucks.
     
  8. trapper

    trapper Smoke Blower

    If you order them I will buy some of them from you. I imagine 500 would last a pretty long time. Send me a pm if interested.
     
  9. azrocker

    azrocker Smoking Fanatic SMF Premier Member

    Sorry I meant 500 degrees. [​IMG] But they do come in 25's so I will holler when I order!
     
  10. trapper

    trapper Smoke Blower

    Sounds good. I am assembling parts for a uds and would be happy to buy some from you.
     

Share This Page