Door flanges inside or out?

Discussion in 'Reverse Flow' started by robcalif, Apr 20, 2014.

  1. robcalif

    robcalif Newbie

    What are your thoughts?
     
  2. smokejumper

    smokejumper Smoking Fanatic

    For what it's worth (about what you paid for it) I say out:

    Easier to install the flanges from the outside.

    Apart from that, no difference in performance.

    Inside flanges have a different cosmetic effect, which can be better if you are good at cutting the door.
     
  3. daveomak

    daveomak Smoking Guru OTBS Member SMF Premier Member

    Flanges on the inside make the opening smaller for removing food....
     
  4. robcalif

    robcalif Newbie

    I like the look of the flanges on the inside. I figure you don't need much in order to create an overlap. I was figuring on using my plasma to cut the doors so they're nice and clean. In addition, I can use some bullet hinges to have a really clean look.

    However, if the cut does not go well, then I'll be flanging the outside.
     

Share This Page