continuation first butt - getting ready HELP!!

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.

flipper0512

Fire Starter
Original poster
Sep 25, 2011
31
10
Woodbury, CT
Ok so im all sest to start my first butt woke up at 6 to get my red bullet electric brinkman going, only one problem, brrr is 34 degrees outside.  smoker peaking at 199, do i have a problem?  I have not probed the meat.
 
Is it just the temps that low or is wind a factor as well? There are much more knowledgeable folks that will chime in, I'm sure. There is talk of using something to shield the wind but I would think you could smoke at 199, just add more time to the already exact science of meat smoking completion time <sarcasm>. I just started the 1st of 3 smokes for a party on Sunday, doing six butts total.

In my undereducated opinion you'll be ok at 199. add time to the equation and as it warms up outside you'll set your temps go up. Shield from wind if that is an issue.

Mike
 
Yes you do have a problem. You need to get the temp up to at least 210-215. That was smart not probing it. Wrap a blanket around the smoker if the exterior is not too hot. A welding blanket works really well. It will cook at 199, but it will take a lot longer, you may need to finish it in the oven. When the sun comes up if you can put the smoker in the sun, that will help too. Good luck
 
wind is not an issue and slowly we are up to 207 and the day will start warming soon, so im going to add meat shortly
 
so put the meat on, which made me loss all my heat.  Took about 40 min and im back to 212, any concerns with bacteria?
 
no not yet, been on since 7 rrunning stead 230 now ill give another hour so so before I probe.  Keeping the smoke light, first butt dont want it to be too smokey.  Thanks for the help.
 
You don't have to worry about too much smoke with a butt. It is such a large piece of meat & the smoke will only penetrate in so far. When you pull it & mix it all up you may wish that you had given it more smoke. But I'm a smokeaholic!  
icon_mrgreen.gif
 
Al has you covered.  Keep the pit closed and let er rip!  Your stall should come at 160 to 165 which is about the time to pop open a cold one!

Good luck and good smoking.
 
ok so here we are.....12 hours on the smoker, still on, just added a few more chunks of wood.  IT is 185, sun is down and temps dropping.  Once that wood is done ill wrap and put in oven at 225 till 190-200 then in towel in coller for at least an hour. 

thoughts concerns?

havent hit a true stall yet but man it is taking its time.............6.7# going for 12 hours at average 235.

Thanks for all the help!!!!!!!!!!!!
 
I shoot for 200*, myself. 195* sometimes will get it there. If it's bone-in, the bone is your best doneness gauge...give a slight twist and pull, and if it wants to pop out, it's ready to rest.

Eric
 
If the smoker temp isn't dropping off the planet from night-fall, I'd hold off. Just handling it to foil it up will cause some extra time, because you'll cold shock it a bit when removing from it's nice and cozy spot. If you need to transfer, it won't hurt anything though.

Just read back a couple posts...your mention of temps dropping already isn't a good sign...I'd get to the "O" with it, or else hitting finished temps may seem to take an eternity...no shame in that, we do what we can...right?

Eric
 
Last edited:
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Hot Threads

Clicky