Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
Recent content by miataman
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
I can not believe I have not touched this smoker project in almost 4 years, but I look at my original post date, and I guess it has been
Well, I’m starting it up again. I just ordered aluminum chimney parts that I hope will work. Part of that is a choke for controlling flow. I got a foot of...
I'll probably just use the temp knobs on the hotplates. I hope the first time or two I use them I'll get a pretty good feel for where they should be to keep temps right. Then I hopefully won't have to adjust them much. That's my hope anyway. If I have to do something else, I'll probably be back...
Here I have the pieces together that I have ready. I have the two sides and back attached to the bottom. I also have the shelf installed to hold up the rack of racks. Under that I have my two hot plates in place.
I have the doors cut and primed, hinges and latches purchased, top primed and...
Now that the sides are ready, I primed everything I had cut, and put final paint on a couple of them for their final color. I think this was one of the doors.
Here are the 3 sides screwed on to the bottom and the bottom with it's final coat. The hole is for the electric cords and some air...
I forgot to mention, I could cut the sides and doors out from the 4x8 sheet of plywood, but had to use the scrap from that to make the top and bottom. I had to glue them together to get them to the size I wanted them.
Four the outside I'm using 3/4" plywood. I figure that will give some insulation. I purchased one sheet of 4x8 and then cut it down. I have it cut to size here and am clamping it together to make sure everything fits before I screw it together.